The GRAIN PEELING MACHINE has a lot unique merits. The motor is the driving device of every machinery, so is the grain peeling machine. How to make the motor low failure rate is the important task for operator.
Voltage imbalance, single-phase operation, winding open circuit failure or breakdown, poor starting and acceleration performance, etc. would cause the grain peeling machine motor fault. There is scorched flavor and stink in motor. Motor overheating, winding burning, single-phase operation, winding failure, bearing failure, etc. will lead to the grain peeling machine scorched flavor. Treatment measures: take timely remedial measures for problems found in the inspection，also by the maintenance cycle of the motor fasten screw and wiring, inspection, clean and maintain the motor and so on.
What’s more, if factory operator find grain peeling machine is working properly, but the quality of the product decline, it means the roller gap needs to be adjusted. You can compress the spring to ensure both ends of the roller same. It is also maybe because that the grinding using time is too long, and severely worn. When you find grain peeling machine yield is relatively small or no powder out, it may be because the screen was blocked. If the produced maize flour temperature is relatively high, what we should to do is to adjust the roller gap. If it is the cause of damaged roller, prompt repairing or replacement are required. In summer, pay attention to grain peeling machine heat dissipation.
After doing this, the grain peeling machine motor failure rate can be effectively reduced.